The Register Other Cameras dialog allows defining the cameras you would like to use in the Multiwatcher screen. You can enter the cameras either manually or automatically (using Zeroconf/Bonjour).
To open the configuration dialog, click on the Manage Cameras link in the configuration page of the Multiwatcher.
Enter one of the following pieces of information for the camera:
IP Address
The symbolic DNS name (provided that DNS has been configured in the Ethernet Interface dialog)
The Zeroconf name (provided Zeroconf has been enabled in the same dialog)
If the camera's web server uses a port other than 80, add the corresponding port. Enter the port behind the actual IP address
or name of the camera followed by a colon (e.g. 192.168.1.233:23335 or mycam.mynet.net:8080).
If you would like to use a camera that is password-protected, enter the corresponding credentials as well. Make sure that you enter the proper User Name and Password.
Click on the Set button to activate your settings and to save them until the camera is rebooted. If you have added cameras or changed existing entries, the camera will automatically start a connection test, which will check if the cameras can be reached.
The automatic camera search feature uses the Zeroconf/Bonjour technology. Make sure that Zeroconf has been activated on all other cameras in the Ethernet Interface dialog so that the cameras can actually be found.
Click on Scan network to start the camera search. The search takes about five seconds.
If new camera are found on the network, the camera enters their Zeroconf names in this dialog. New entries are highlighted in yellow. Click on the Set button to enter the defined cameras and to save them until the camera is rebooted. The camera will automatically start a connection test, which will check if the cameras can be reached.
If the camera finds no cameras or only cameras that are already listed, a popup window will inform you of this fact.
To delete one or more entries, activate the Remove option and confirm your selection by clicking on the Set button.
New or changed entries will be tested automatically. To test the connection to all cameras, activate the Test all entries option and click on Set.
The connection test will check if it can reach all other cameras listed in this dialog. When doing so, this camera will get and display the camera information, a preview image and information on the last alarm.
If errors occur, you should make the appropriate changes. The error message will give you a hint, which column of the entry requires corrections.
Cliquez sur le bouton Définirpour activer les paramètres et les sauvegarder jusqu'au prochain démarrage de la caméra.
Cliquez sur le bouton Config. usine pour réinitialiser tous les paramètres de cette boîte de dialogue selon la configuration initiale (ce bouton n'est peut-être pas disponible pour toutes les boîtes de dialogue).
Cliquez sur le bouton Restaurer pour annuler les dernières modifications qui n'ont pas été enregistrées définitivement dans la caméra.
Cliquer sur le bouton Fermer pour fermer la boîte de dialogue. Lors de la fermeture de la boîte de dialogue, le système vérifie si les paramètres ont été modifiés. Si tel est le cas, le programme vous demande si vous souhaitez enregistrer ou non de façon permanente la configuration globale.